Breville BES830XL manual Filling the Water Tank, PRE-WARMING the Cups

A MINUTE TO LEARN - "PRESSURIZED" DUAL WALL FILTERS

PERFECTING YOUR SKILLS - "NON-PRESSURIZED" SINGLE WALL FILTERS

No Steam? 1	2	3	4	Any	1
				Questions?

							HELP!
	2000						www.breville.com
	2200
	1750
	1500
	1250
	1000
		750
	500
Fill Water Tank,			Clean hole with pin	Remove tip	Soak tip in hot water
						Or refer to the
then re-try						Instruction Book

18

BES830XL_IB_Issue1,09.indd 18-19

"NON-PRESSURIZED" SINGLE WALL FILTERS FOR ASPIRING BARISTAS

Experiment with grind size, grind amount and tamp.

The Die-Cast Programmable Espresso Machine is supplied with two “Non-Pressurized” Single Wall Filters - 1 x single shot and 1 x double shot. These fi lters provide no additional slowing of the water fl ow rate, hence experimentation with the grind size, grind amount and tamp force is required to achieve favorable results.

These fi lters are suited to both pre-ground vacuum packed espresso as well as freshly ground beans. A great espresso is a balance of main fl avor elements: acidity, aroma, bitterness, body, nuttiness, and sharpness. By using the Single Wall Filters you are free to explore the world

of espresso by adjusting grind, grind amount and tamp to extract a rich variety of fl avors.

STEP 1 - FILLING THE WATER TANK

•Ensure the Power is off and the Selector Control, on the side of the machine, is set to the “Stand By” position.

•Unplug the power cord from the power outlet.

•Remove the portafi lter if locked into the group head and move the steam wand to the side of the machine.

•Remove the water tank by sliding out using the handle insert in the front of the water tank.

•As the water tank is removed, a black tube slides and extends out from the water tank storage area. Do not touch or try to remove this tube, it will automatically slide back into position when the water tank is re inserted.

•Fill the water tank with cold, tap water to the maximum mark on the water window

and slide the water tank carefully back into position in the machine.

•Ensure the Selector Control is in the “Stand By” position and plug the power cord into a 110/120V power outlet.

•Press the POWER button to ‘On’, the POWER button surround will fl ash while the machine is heating. When the correct temperature has been reached, all the button surrounds on the control panel will illuminate.

NOTE:

Check the water level before use and replace the water daily. The water tank should be refilled with fresh, cold tap water before each use. Do not use mineral or distilled water or any other liquid.

STEP 2 - PRE-WARMING THE CUPS

This will help maintain the espresso’s optimal temperature when brewed into the cups. The Cup Warming Plate will start to warm as the machine heats.

Run hot water from the group head without the portafi lter inserted by holding down the single shot button on the front, right hand side of the machine, then place the cups on the warming tray.

19

4/1/10 11:02:42 AM