Breville BES860XL manual The Art Of Texturing Milk

THE ART OF TEXTURING MILK

The Breville Barista Express comes complete with a Commercial Style Swivel Steam Wand and Stainless Steel Frothing Attachment. When using the frothing attachment on the steam wand a large amount of froth is easily created.

If less froth is desired, remove the frothing attachment from the steam wand before texturing. To remove the frothing attachment, ensure it is cool then simply pull down and remove. The frothing attachment can be stored

inserting it, from either end, onto the steam wand and pushing firmly upwards onto the rubber surround.

ssFill the stainless steel frothing jug maximum 1⁄2 full with cold, fresh milk.

ssTurn the Steam selector dial to the ‘Steam’ position. The red steam light will start to flash indicating that the machine is heating to create steam.

ssWhen the steam light stops flashing it is ready to use.

ssBefore inserting the wand into the milk, pause the steam by returning the dial back to the ‘STAND BY’ position. This will avoid splashing the milk out of the jug (this pause function lasts for 6 seconds before exiting steam mode).

ssInsert the wand into the milk and return the Steam dial back to ‘Steam’.

ssTo stop, return the steam dial to the ‘STAND BY’ position and remove the jug.

NOTE: When the espresso machine creates steam, a pumping noise can be heard. This is the normal operation of the 15 Bar pump.

NOTE: After 5 minutes of continuous steaming, the machine will automatically disable the steam function. The steam light will flash. When this occurs return the steam dial to the ‘STAND BY’ position.

in the storage tray located behind the drip tray, if not used regularly.

To refit the frothing attachment ensure it is securely attached to the steam wand by

WARNING: MILK SHOULD NOT BE ALLOWED TO RUN OVER THE TOP OF THE FROTHING ATTACHMENT, OTHERWISE IT WILL NOT FUNCTION PROPERLY. TO AVOID SPLATTERING OF HOT MILK, DO NOT LIFT THE END OF THE FROTHING ATTACHMENT ABOVE THE SURFACE OF THE MILK WHILE FROTHING. ENSURE THE STEAM DIAL IS IN THE ‘STAND BY’ POSITION BEFORE REMOVING THE FROTHING JUG.

41