Briggs & Stratton RIDER 11 BIO, RIDER 16, RIDER 13 BIO manual Reparation instructions

Reparation instructions

5

Remove the fuel line hose clamp from the fuel pump and pull the fuel line downwards.

Tie the hose higher than the fuel tank level.

6

Release the exhaust pipe clamps, and then remove the exhaust pipe.

7

Clamp together the wire holder under the engine pulley with a pair of flat pliers and pull the wire holder downwards.

8

Insert tool no. 506 79 06-01 into the centre of the engine pulley. Unscrew and remove the socket head cap screw which holds the pulley and the engine axle together. Use tool no. 506 89 92-01 as a holder-on. Remove the pulley from the engine axle.

9

Remove the engine attachments, two on each side of the engine, and remove the engine from the mower.

Watch where the battery’s negative cable is connected. Disconnect it from the engine if necessary.

Lift the engine out of the mower, take care of the key and spacer tube, located on the engine shaft.

24 – English