Briggs & Stratton RIDER 13, RIDER 11 BIO manual Microswitch Seat, Microswitch Neutral Position

Microswitch: Seat Microswitch: Neutral Position

1.Fold up the seat and remove the spring disc with spring and spacer sleeve. The microswitch holder is released.

2.Disconnect the cable connections from the microswitch.

3.Press in the fasteners and remove the microswitch from the holder.

Assembling is done in the reverse order without setting.

Microswitch: Mowing Deck

1.Loosen the right-hand wing cover.

2.Remove the inner protecting plate on the gear lever carrier.

3.Release the connector from the microswitch.

4.Remove the microswitch.

Assembling is done in the reverse order without setting.

1.Remove the transmission cover.

2.Check the hydrostatic cable adjustment.

3.Adjust the microswitch so that it is activated by the highest point in the hydrostatic arm’s path when no driving pedal is pressed.

4.Adjust the microswitch so that it is definitely activated by the hydrostatic arm, but allows extra motion (it must not bottom out). Tip: Hold a feeler gauge between the switch and the arm when making the adjustment.

5.Replace the transmission cover.