Briggs & Stratton RIDER 13 manual Refitting hydrostatic transmission wire, Reparation instructions

Reparation instructions

Refitting hydrostatic transmission wire

1

3

Press the wire casing in the front holder in the middle bracket.

4

Screw the front ball joint onto the new transmission wire and tighten the lock nut.

2

Run the wire through the mower so that it follows the same route as the old wire.

Screw tight the hydrostatic transmission wire’s clamp. Press the linkage in its holder and fit the lock spring.

5

Screw tight the linkage on the lower part of the transmission wire. Screw 10-12 turns so that the linkage has the correct length.

42 – English