Briggs & Stratton RIDER 11 manual Adjusting Rider 11 Bio and Rider 13 Bio, Reparation instructions

Reparation instructions

2	2
Adjusting Rider 11 Bio and Rider 13 Bio	Adjusting Rider 16

•Remove the front cover and the right-hand fender.

•Unscrew the nut (1) on the parallel strut. Remove the locking clips (3) and the parallel strut (2).

•Turn the fork anticlockwise to raise the cover’s rear edge, clockwise to lower the cover’s rear edge.

•Once adjustment is complete, refit the parallel strut and clip and tighten the nut.

•Recheck the alignment of the cutting unit after adjustment.

•Refit the right-hand fender and hood.

•Remove the front cover and the right-hand fender.

•Loosen the nuts on the parallel strut.

•Screw in (shorten) the strut to lower the rear edge of the cover.

Screw out (extend) the strut to raise the rear edge of the cover.

•Tighten the nuts after adjustment.

•On completion of the adjustment the unit’s parallelism should be re-checked.

•Fit the right-hand fender and the front hood.

48 – English