Briggs & Stratton RIDER 16 Removal/installation of wire wheel, Reparation instructions, English

Reparation instructions

Removal/installation of wire wheel

1.Remove the frame plate.

2.Detach the steering wires' rear attachment (1) .

3.Remove the screw (2) and detach the wire wheel (5).

4.Remove the bearing's circlip (3) and knock out the bearing (4).

5.To install the wire wheel, the reverse order is applied.

The screw (2) is to be mounted in the rear hole on the frame. The bushing (6) is to be placed between the frame and the cable pulley.

Ensure that the cables are properly situated under the steering cable rollers (7) in the frame tunnel.

Ensure that the steering wheel is in the centre position when the rear wheels are centred. Re- set the chain on the steering column’s sprocket or adjust the rear fixture (1) for the steering cables as needed.

Hold the cables with, for example, a wrench when mounting so that they do not twist.

After installation, check the wire tension (see “Checking and adjusting steering wires”).

30 – English