Briggs & Stratton RIDER 11 BIO, RIDER 16 Adjusting cutting height area, Reparation instructions

Reparation instructions

Adjusting cutting height area

1

3

2

11

Remove the right-hand fender.

2

Raise or lower the entire mowing deck by screwing the nuts up or down.

If the highest cutting height is raised by 5 mm (3/16") the other fixed cutting heights will also be raised by the same amount.

Adjusting cutting height

•Loosen the nuts on the height setting arm.

•Adjust so that the distance between the stop for the lowest height setting and the protective frame is 5 mm (3/16").

•Tighten the nuts.

•Check that the parallelism has not changed. If it has changed, the parallelism must be readjusted again.

•Check and adjust the cutting unit’s ground pressure as set out (see “Checking and adjusting cutting unit ground pressure”) if necessary.

•Fit the nose.

IMPORTANT INFORMATION

The parallelism and height must be adjusted again when changing the cutting unit.

English – 49