Briggs & Stratton RIDER 13 manual Removal/installation of gear box, Reparation instructions, Rider

Reparation instructions

Removal/installation of gear box

Rider 11

1

•Block-up the machine in front of the rear frame and dismantle the rear wheels.

•Remove the cover from over the gear box.

2

•Release the tensioning wheel spring (1).

•Unfasten the clutch wire (2), and detach the belt from the gear box pulley.

•Detach the gear and brake wires (3 and 4).

•Insert a garage jack under the gear box and unscrew the gear box's five holder screws (5).

3

•Lower the garage jack and pull out the gear box.

•Installation of the gear box is carried out in the reverse removing gear box order

•After installation, check that the clutch, brake and gear wires are correctly adjusted (see “Checking and adjusting brake wire”, “Checking and adjusting gear control” and “Checking and adjusting freewheel clutch”).

Removing/installation of hydrostatic transmission Rider 13 H/13 H Bio and Rider 16 H

1

•Block-up the machine in front of the rear frame and remove the back wheels.

•Remove the transmission cover.

2

•Release the tensioning wheel spring (1).

•Remove the fan (2), it is held by a circlip.

•Work off the drive belt (3).

•Remove the oil tank (4).

•Release the brake wire spring and remove the brake wire from the brake lever (concealed under the oil tank).

•Release the hydrostatic transmission link (5) in the front ball joint.

•Remove the screw (6) holding the arm.

•Remove the freewheel clutch control (7) with its spring.

English – 37