Briggs & Stratton RIDER 13 BIO, RIDER 11, RIDER 16 Installation of swing axle, Rider 13 and

Reparation instructions

Installation of swing axle

1

•Grease half of the axle (the half that has not been turned down) and press it from the back into the steering spindle (see diagram).

•Attach the washer and circlip on the swing axle's inner holder.

•Fix the dust guard (with a thin lip behind) approx. 2/3 of the way in on the axle and lubricate the axle on both sides of the dust guard.

3 Rider 11

•Attach a washer and circlip onto the swing axle

(1).

•Firmly secure the wires' holder plates (2), as well as the gear and brake wires (3 and 4).

•Connect the belt onto the pulley and tightly screw the tensioning wheel arm (5) onto the rear frame.

•Attach the clutch wire (6) and the tensioning wheel spring (7).

3 Rider 13 and 16

2

Roll the rear frame forwards and press it in on the swing axle.

•Fit the washer and circlip on the swing axle.

•Fit the hydrostatic transmission wire and its casing (2+4).

•Fit the cable on the neutral position contact (5).

•Fit the rear belt (8).

•Fit the brake wire on the arm under the tank and the casing’s holder on the rear frame (6).

•Fit the tensioning wheel spring (1).

•Fit the hydrostatic transmission’s fan and the circlip (7).

4 . Check that wires and controls are correctly adjusted (see Inspection and adjusting of respective wires). Finally, fit the cover on the transmission/gearbox.

Check the setting of the neutral position switch on machines with hydrostatic transmission, see ”Electrical system\Microswitch neutral position”.

36 – English