Briggs & Stratton RIDER 11 BIO, RIDER 16, RIDER 13 BIO Ignition and Starter Lock, Main fuse

Ignition and Starter Lock Main fuse

1.Loosen the right-hand wing cover.

2.Remove the inner protecting plate on the gear lever carrier.

3.Release the contact box from the ignition lock by pulling it straight down.

4.Remove the ignition key and the rubber seal.

5.Remove the nut and the ignition lock.

Assemble the parts in the reverse order. Make sure the connector ends up in the proper position (click- lock).

The fuse is placed in a detachable holder under the battery case’s cover, in front of the battery.

Type: Flat pin, 15 A.

Do not use any other type of fuse when replacing.

A blown fuse is indicated by a burnt connector.

Pull the fuse from the holder when replacing.

The fuse is there to protect the electrical system.

If it blows again shortly after replacement, it is due to a short circuit, which must be fixed before the machine can be put into operation again.