Briggs & Stratton RIDER 16 manual Replacing engine, Reparation instructions, Important Information

Reparation instructions

Replacing engine

The figures under ”Assembling” show the newer Rider 16 model (2003-). For

older designs (R16 up to the 2002 model), and Rider 11 and 13 see ”Dismantling

the engine”. The text applies to all versions.

2

Position the pulley with tool no. 506 79 06-01 and

tighten it with moment (70-80 Nm/50-56 lbft). Use

tool no. 506 89 92-01 as a holder-on.

IMPORTANT INFORMATION

When installing the engine, it is important that the pulley groove (1) is in a position so the outgoing axle key (2) fits into the groove (see diagram). Also check that both spacing collars (3) and the key (2) are firmly attached on the engine axle. Grease the engine axle.

1

3

Position the wires in the wire holder, clamp the holder together and, from below, lead it up through the centre of the belt tensioner until it hooks over the tensioner's upper edge.

Lower the engine and tighten the engine attachments (two on each side of the engine) with moment (20-25 Nm/14-18 lbft).

4

Hook on the throttle wire at the carburettor and fit the wire clamp without tightening it.

English – 25