Briggs & Stratton RIDER 11 manual Checking and adjusting throttle control, Rider 13 and Rider

Reparation instructions

Checking and adjusting throttle control

Rider 13 and Rider 16

1.Detach the locking nut (1) on the ball joint.

2.Push the lock spring (2) forwards far enough for the spherical socket (3) to be lifted off from the pivot on the lever (4).

3.Press the throttle pedal to the bottom and move the lever (4) forwards as far as it goes using a screwdriver.

4.Adjust the position of the spherical socket (3) on the connecting rod (5) so that it just fits over the pivot on the lever. Fit the spherical socket on the pivot.

5.Lock the setting with the lock nut (1) and press the locking spring (2) into position.

IMPORTANT INFORMATION Check that the locking spring goes through the hole in the spherical socket.

Replacing articulated steering bearing

1

•Remove the engine according to the earlier description (see “Removing engine”).

•Block up the ride-on mower in front of the articulated steering.

2 Rider 11

•Release the tensioning wheel spring (1).

•Release the clutch, gear and brake wire (2, 3 and 4) and remove the wires' holder plates (5 and 6).

2 Rider 13 and Rider 16

2

5

3 1

4

•Release the tensioning wheel spring (1).

•Release the hydrostatic transmission wire (2) from the arm (3) and the casing from the holder

(4).

•Release the cable from the neutral position contact (5).

•Release the brake wire from the arm under the tank and the casing’s holder from the rear frame

(6).

English – 33