Brother 882-W02 Using the Foot Controller, Adjust the sewing speed with the speed control slide

SEWING

fAdjust the sewing speed with the speed control slide.

* You can use this slide to adjust sewing speed during sewing.

aSlow

bFast

gPresssewing.the “Start/Stop” button to start

* Guide the fabric lightly by hand.

Memo

•When the foot controller is being used, you cannot start sewing by pressing the “Start/ Stop” button.

hPresssewing.the “Start/Stop” button again to stop

iPress the “Thread Cutter” button to trim the upper and lower threads.

￿The needle will return to the up position automatically.

CAUTION

•Do not press the “Thread Cutter” button after the threads have been cut. Doing so could tangle the thread or break the needle and damage the machine.

•Do not press the “Thread Cutter” button when there is no fabric set in the machine or during machine operation. The thread may tangle, possibly resulting in damage.

Note

•When cutting thread thicker than #30, nylon monofilament thread, or other decorative threads, use the thread cutter on the side of the machine.

jWhen the needle has stopped moving, raise the presser foot and remove the fabric.

Memo

•This machine is equipped with a bobbin thread sensor that warns you when the bob- bin thread is almost empty. When the bobbin thread is nearly empty, the machine auto- matically stops. However, if the “Start/Stop” button is pressed, a few stitches can be sewn. When the warning displays, re-thread the machine immediately.

■Using the Foot Controller

You can also use the foot controller to start and stop sewing.

CAUTION

•Do not allow fabric pieces and dust to collect in the foot controller. Doing so could cause a fire or an electric shock.

Memo

•When the foot controller is being used, you cannot start sewing by pressing the “Start/ Stop” button.

•The foot controller cannot be used when embroidering.

•The foot controller can be used for sewing utility and decorative stitches when the embroidery unit is attached.

2

Sewing Basics

61