Brother 882-W02, 882-W01 operation manual Using the Spool Stand, How to Assemble the Spool Stand

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS

Using the Spool Stand

The included spool stand is useful when using thread spools with a large diameter (cross-wound thread). The spool stand can hold two spools of thread.

1 2 3

4 5 6

7 8

No.	Part Name	Part Code
1	Telescopic thread guide	XE0776-001
2	Spool support	XE4637-001
3	Spool pin × 2	XA6313-051
4	Screw and washer	XC7568-051
5	Spool cap (XL) × 2	XE0779-001
6	Spool holders × 2	XA0679-050
7	Spool cap base × 2	XE0780-001
8	Spool felt × 2	XC7134-051

CAUTION

•Do not lift the handle of the machine while the spool stand is installed.

•Do not push or pull the telescopic thread guide or spool pins with extreme force, otherwise damage may result.

•Do not place any object other than spools of thread on the spool support.

•Do not try to wind thread on the bobbin while sewing using the spool stand.

■How to Assemble the Spool Stand

aFully extend the telescopic thread guide shaft, and then rotate the shaft until the two internal stoppers click into place.

bInsert the telescopic thread guide into the round hole at the center of the spool

support, and then use a screwdriver to securely tighten the screw (a) from the reverse side.

aScrew

Note

•Make sure that the stoppers on the tele- scopic thread guide shaft are firmly in place and that the top of the thread guide is directly above the spool pins. In addition, check that the shaft is securely tightened in the spool support.

9