Brother 882-W02, 882-W01 operation manual Bar Tacks, 129

SEWING THE STITCHES

Bar Tacks

Use bar tacks to reinforce areas that will be subject to strain, such as pocket corners.

		Presser		Stitch width		Stitch length		Twin
Stitch	Stitch name		Applications	[mm (inch)]		[mm (inch)]
		foot						needle
				Auto	Manual	Auto	Manual
	Bar tack		Reinforcement at opening of	2.0	1.0 - 3.0	0.4	0.3 - 1.0
			pocket, etc.					NO
				(1/16)	(1/16 - 1/8)	(1/64)	(1/64 - 1/16)

aSelect .

bAttach buttonhole foot “A” and set the scale to the length of the bar tack you wish to sew.

aPresser foot scale

bCompleted length measurement

c5 mm (approx. 3/16 inch)

Memo

•Bar tacks can be between 5 mm (approx. 3/16 inch) and 28 mm (approx. 1-1/16 inches). Bar tacks are usually between 5 mm (approx. 3/16 inch) and 10 mm (approx. 3/8 inch).

cSet the fabric so that the pocket moves toward you during sewing.

Note

•Pass the thread underneath the presser foot.

•Slide the outside frame of the buttonhole foot backward as far as possible as shown in the illustration, making sure that there is no gap behind the part of the foot marked “A”. If the buttonhole foot is not slid back as far as possible, the bar tack will not be sewn to the correct size.

dCheck the first needle drop point and lower the presser foot.

3

Utility Stitches

a2 mm (approx. 1/16 inch)

129