Brother 882-W01, 882-W02 operation manual Using the Spool Pin

LOWER THREADING

kCutbobbin.the thread with cutter and remove the

Memo

•When removing the bobbin, do not pull on the bobbin winder seat. Doing so could loosen or remove the bobbin winder seat, and could result in damage to the machine.

CAUTION

•Setting the bobbin improperly may cause the thread tension to loosen, breaking the needle and possibly resulting in injury.

■Using the Spool Pin

You can use the main spool pin to wind the bobbin before sewing. You cannot use this spool pin to wind the bobbin while sewing.

aTurn the main power to ON and open the top cover.

bAlign the groove in the bobbin with the spring on the bobbin winder shaft, and set the bobbin on the shaft.

aGroove in the bobbin

bSpring on the shaft

cPivot the spool pin so that it angles upward. Set the thread spool on the spool pin so that the thread unwinds from the front of the spool.

aSpool pin

bSpool cap

cThread spool

dSpool felt

dPush the spool cap onto the spool pin as far as possible, then return the spool pin to its original position.

eWhile holding the thread with both hands, pull the thread up from under the thread guide plate.

aThread guide plate

40