Brother 882-W01, 882-W02 operation manual 332, Chart

TROUBLESHOOTING

Problem	Cause		Solution	Page
Fabric does not feed	Feed dogs are set in the down position.			105
through the machine		Press	, and then turn the handwheel to
		raise the feed dogs.
	Stitches are too close together.	Lengthen the stitch length setting.		67
	Wrong presser foot was used.	Use the correct presser foot.		“STITCH SETTING
				CHART”
	Needle is turned, bent or the point is dull.	Replace the needle.		56
	Thread is entangled.	Cut the entangled thread and remove it from		—
		the race.
Fabric puckers	There is a mistake in the upper or bobbin	Check the steps for threading the machine		43, 46
	threading.	and rethread it correctly.
	Using improper needle or thread for the	Check the “Fabric/Thread/Needle		58
	selected fabric.	Combination” chart.
	Thread tension is set incorrectly.	Adjust the thread tension.		67, 227
	Stitches are too long when sewing thin fabrics.	Shorten the stitch length.		67
	Needle is turned, bent or the point is dull.	Replace the needle.		56
	Spool cap is set incorrectly.	Check the method for attaching the spool cap,		46
		then reattach the spool cap.
	Wrong presser foot.	Use the correct presser foot.		“STITCH SETTING
				CHART”
High-pitched sound	Dust or lint is caught in the feed dogs.	Remove the dust or lint.		326
while sewing
	Pieces of thread are caught in the race.	Clean the race.		326
	Upper threading is incorrect.	Check the steps for threading the machine		46
		and rethread the machine.
	There are scratches on the race.	Replace the race, or consult your authorized		326
		dealer.
	A bobbin designed specifically for this machine	Incorrect bobbins will not work properly. Only		43
	is not used.	use a bobbin designed specifically for this
		machine.
Character pattern	Wrong presser foot was used.	Attach the correct presser foot.		“STITCH SETTING
does not turn out				CHART”
	Pattern adjustment settings were set incorrectly.	Revise the pattern adjustment settings.		153
	Did not use a stabilizer material on thin fabrics	Attach a stabilizer material.		152
	or stretch fabrics.
	Thread tension is set incorrectly.	Adjust the thread tension.		67, 227
	Fabric was pulled, pushed or fed at an angle	Sew while guiding the fabric with your hands		60
	while it was being sewn.	so that the fabric is fed in a straight line.

332