Messages on the LCD |
| Probable Cause |
|
| |
DOCUMENT JAM | n Document loading error | |
| (1) | The document rear sensor detects no leading edge of a |
|
| document within 10 seconds from the start of document |
|
| loading operation. |
|
| (The document rear sensor stays OFF even after the |
|
| document has been fed when the document front sensor |
|
| was ON.) |
| (2) | The loaded document is too short. |
|
| (Since the document is shorter than the distance between |
|
| the document front and rear sensors, the document front |
|
| sensor is turned OFF before the document rear sensor is |
|
| turned ON.) |
|
| |
CLEAN UP SCANNER | In the scanning compensation data list printed by the | |
| ||
| white level data is faulty. | |
| (This message may appear only in the maintenance mode.) | |
|
| |
SCANNER ERROR | In the scanning compensation data list printed by the | |
| ||
| white level data is faulty. | |
| (This message may appear only in the maintenance mode.) | |
|
| |
PRINTER FAULT | The thermistor in the recording head caused a heat error. | |
|
| |
CHANGE CARTRIDGE | The ribbon sensor detects that no ink ribbon is loaded. | |
|
|
|
MACHINE ERROR _ _ | "_ _" | indicates an error code. Refer to Section [ 2 ] on the |
or | following pages. | |
MACHINE ERR _ _ _ _ |
|
|
|
| |
PC BUSY OR FAIL | After connected with the host computer, the equipment has | |
| received no response from the computer. (A communications | |
| error has occurred.) | |
|
|
|
If only an alarm beep is heard without any message on the LCD when the equipment is powered up, the ROM or RAM will be defective.
VI - 2
