WSW04 (TRANSFER facility setting)
Selector | Function |
|
|
| Setting and Specifications | ||
No. |
|
|
| ||||
|
|
|
|
|
|
| |
|
|
|
|
| |||
1 | Earth function in transfer facility |
| 0: Provided | 1: Not provided | |||
|
|
|
|
|
|
|
|
|
| No. | 2 | 3 |
|
|
|
2 | Dual tone detection frequency in |
| 0 | 0 | : | 350 and | 440 Hz (A) |
3 | ICM recording |
| 0 | 1 | : | 440 and | 480 Hz (B) |
|
| ||||||
|
|
| 1 | x | : | 480 and | 620 Hz (C) |
4 | Tone detection sensitivity in ICM |
| 0: OFF | 1: High | |||
recording |
| ||||||
|
|
|
|
|
|
| |
|
| No. | 5 | 6 |
|
|
|
5 |
|
| 0 | 0 | : | 200 ms |
|
| Earth time length for earth |
| 0 | 1 | : | 300 ms |
|
6 | function |
| 1 | 0 | : | 500 ms |
|
|
|
| |||||
|
|
| 1 | 1 | : | 700 ms |
|
|
| No. | 7 | 8 |
|
|
|
7 | Break time length for flash |
| 0 | 0 | : | 80 ms |
|
|
| 0 | 1 | : | 110 ms |
| |
| function |
|
| ||||
8 |
| 1 | 0 | : | 250 ms |
| |
|
|
| |||||
|
|
| 1 | 1 | : | 500 ms |
|
|
|
|
|
|
|
|
|
NOTE: Selectors 1 and 5 through 8 are not applicable in those countries where no transfer facility is supported.
NOTE: Selectors 2 through 4 are applicable to those models equipped with a
NOTE: Selectors 2 and 3 are applicable in the U.S.A.
•Selector 1: Earth function in transfer facility
This selector determines whether or not the earth function is added to the transfer setting menu to be accessed by the function switch.
•Selectors 2 and 3: Dual tone detection frequency in ICM recording
If the equipment detects either of the frequencies set by these selectors in ICM recording, it will disconnect the line. For example, if these selectors are set to “0, 0,” the equipment will disconnect the line upon detection of 350 Hz or 440 Hz.
•Selectors 4: Tone detection sensitivity in ICM recording
Setting this selector to “1” increases the tone detection sensitivity in ICM recording.
•Selectors 5 and 6: Earth time length for earth function
These selectors set the
This setting is effective only when the earth function is selected for the R key by using the function switch.
•Selectors 7 and 8: Break time length for flash function
These selectors set the break time length.
This setting is effective only when the flash function is selected for the R key by using the function switch.
V - 15
