20
wall(for aesthetic value only --Equipment Control Module need not be
leveledfor proper operation)and mark wall through2 mounting holes.
2. Drill two 3/1 6--in.mountin g holes in wall where marked. Th ermostat may
bemounted to a standard junctionbox if desired. Holepattern on Equip-
mentControl Module matchesjunction box mounting holes.
3. Secure rearplastic Equipment Control Module to wallwith 2 screws and
anchorsprovided. Additional mounting holes are availablefor more se-
cure mounting if needed. Make sure allwires extend through hole in
EquipmentControl Module.
4. Adjust length and routing of each wire to reach prop er connectorblock
and terminal on EquipmentControl Module with 1/4--in.extra length.
SeeFig. 14.
A07219
Fig.14 -- Equipment ControlModule