Bryant T6--NAC, T6--NHP, T6--PAC, T6--PHP Configuration Options Selecti on

Option31* — DaylightSavings Time Configuration

(programmablemodels only)

Option 32 — FurnaceHeat Stagin g

Option 33 — Singleor Two--Piece Installation

Option 99 — Resetto Factory Defaults

TOENTER CONFIGURATION MODE

Press andhold FAN button for approximately 10 sec.The Display Module is

now in configuration mode. It will automatically exit this mode if no button is

pressed for 3 minutes. Pressing either FAN or DONE button will exit

configurationmode immediately.

WHILEIN CONFIGURATION MODE

The option number is displayed in the heat setpoint locatio n and the

configuration setting is displayed in the cool setpoin t location. On the

T6--PAC/PHP (programmable)models, a box willsurround the option number.

Themode button is used tomove the box between the two displayedvalues. The

soft keys below thelisted values may also be used to move the box between

selectedvalues. The value inside the box is changed by usingthe UP/DOWN

buttons.On the T6--NAC/NHP (non--programmable)models, one of the values

willbe flashing. The mode button is used to change which value is flashingor

theHome and Sleep buttonsmay also be used toselect which valueto flash. The

value that isflashing is changed by using the UP/Down buttons. Allchanges

made are saved at the time of selection and will be saved inthe event of the 3

minutetime--outor when installerexits from configurationmenu.

Configuration Options —Selecti on

Option01 — Equipment Type

HPmodel — Range: HP,AC, H, C.