Buffalo Technology TSXE80TLR5 Power Button, Info LED, Error LED, LCD Display, Display Button

1 Power Button

Power ON/OFF: Press and hold the Power Button for 3 seconds until it beeps.

Note: To power on, connect the AC cable and wait for 10 seconds. Then press the Power Button.

2 Info LED

If there is a message about the current status, the amber info LED is illuminated. Check the LCD display for current status.

3 Error LED

The red error LED is illuminated when an error occurs. Check the LCD display for more information.

4 LAN1 LED

When the LAN Port 1 is connected to a network, it is illuminated in green (the light next to the LAN Port 1 will be illuminated as well).

5 LAN2 LED

When the LAN Port 2 is connected to a network, it is illuminated in green (the light next to the LAN Port 2 will be illuminated as well).

6 LCD Display

Displays the status of the TeraStation.

7 Display Button

Switches between the different display modes.

8 Function Button

Use this button to perform the following operations:

•DirectCopy

•Removal of USB devices

•Rebuild RAID after replacing hard drives

9 Drive Lock

Open the front panel with the key to replace hard drives or press the Reset Button.

10 Reset Button

With the TeraStation powered on, hold down this button until it beeps (about 5 seconds) to reset the TeraStation’s IP address and password to the factory defaults. The password will not be reset if this functionality has been disabled from within the Web Admin interface.

Note: To access the TS-RXL series’ reset button, insert the tip of an unfolded paper clip.

11 Status LEDs 1 - 4

LEDs 1 through 4 will be illuminated in green when the corresponding hard drives are accessed. If an error occurs on a hard drive, the corresponding LED will be illuminated or flash in red or amber.

12 Factory Use Only

TS-XEL TeraStations do not have this port.

13 UPS Port

Connect a UPS (Uninterruptible Power Supply).

TS-XEL TeraStations do not have this port.

14 USB Connector (USB 2.0/1.1 Series A)

Compatible Buffalo USB hard drives, USB flash drives, and digital cameras can be connected. USB hubs are not supported.

15 LAN Port 1

Connect to a router, hub, or switch on your Ethernet network.

16 LAN Port 2

Use this second Ethernet port for redundancy or backup. For backup, a second TeraStation may be connected directly.

17 Power Mode Switch

Switches between AUTO and MANUAL power modes (page 12).

18 Power Connector

Use the included AC cable to connect to an UPS, surge protector, or outlet.

19 Fan

Do not block the fan when installing the unit.

20 Anti-Theft Security Slot

You can also secure it using an off-the-shelf wire lock.

21 UID Button

The blue LED next to the UID button will be illuminated or turned off every time you push this button on the front or back.

TeraStation User Manual 11