Buffalo Technology TS-RXL, TSXE80TLR5 user manual Using RAID 1 mode

Click [System] - [Storage] - [RAID Array] in the Web Admin interface.

Click the array you want to set.

Click hard disks (Disk 1 and Disk 2, or Disk 3 and Disk 4) in RAID1.

Using RAID 1 mode

1 Change system to normal mode (page 20).

2

3

4

5

1Select [RAID 1].

2Click [Create Raid Array].

	Note:
	After the RAID array is changed, the TeraStation will perfom a RAID check that will take about 5 hours per TB. File
	transfers will be slower during this period. While the “RAID ARRAY x Resyncing” message is displayed on the LCD
	screen, do not turn off the TeraStation. If you turn it off, the RAID check will start over.
6	The [Confirm Operation] screen will appear. Enter the number shown in the [Confirmation Number] field within
	60 seconds, and click [Apply].
7	Follow the instructions displayed on the screen.

You have set up a RAID 1 array. Repeat the steps to create a second RAID 1 array with the other two drives, or refer to page 26 to configure a hot spare with one of the remaining drives. Turn to page 43 to create a shared folder.

TeraStation User Manual 24