5_ELURA2_E(93-115) 7/25/00 17:25 Page 108

E

the MultiMediaCard

(ELURA2 MC only)

Using

 

5.Press the CARD +/– buttons to select the still image to be combined.

Your currently recording image is combined with the pre-recorded still image.

6.Select MIX TYPE.

CARD CHROMA, CARD LUMI., CAM. CHROMA settings appear.

7.Select the desired setting.

8.Select MIX LEVEL.

9.Adjust the mix level.

Turning the SELECT dial upwards adjusts to the left and turning downwards adjusts to the right.

10.Close the menu.

The name of your selection flashes in the display. On/Off

11.Press the D.EFFECT ON/OFF button.

The name of your selection stops flashing.

Each time you press the ON/OFF button, your selection is activated (display lights continuously) or deactivated (display flashes).

For a moving image

1.Press the start/stop button to start and stop recording.

• The combined images are recorded onto the cassette.

For a still image

1.Press the PHOTO button halfway down and hold it.

F flashes white in the display as the camcorder adjusts the focus and it is displayed continuously as a green mark when the camera is ready to take the image.

2.Press the PHOTO button fully down to record the image to the cassette.

F disappears from the display.

The combined images are recorded onto the cassette for approximately 6 seconds.

You cannot use Card Mix in the Low Light recording program (in MOVIE and P.SCAN modes).

If you change the position of the POWER dial or move the program selector from Q to [ Easy Recording mode, select your still image for Card Mix again.

When setting Card Mix, you must carry out steps 1 to 5.

108

Page 108
Image 108
Canon 2 MC 108, Select MIX Type, Press the D.EFFECT ON/OFF button, Press the start/stop button to start and stop recording