Checking the Battery Level, Turn the to | Canon EOS-1V HS manual

Installing the Battery and Checking the Battery Level

Checking the Battery Level

Check the battery level after replacing the batteries or before using the camera.

Battery Life (No. of Rolls)

Temperature	Rolls
At 20˚C	75 (50)
At –20˚C	18 (12)

Turn the < > to < >.

The battery level will be checked automatically and the LCD panel will then display one of the following battery level icons:

: Battery level OK.

: Keep spare battery handy.

: Battery will soon be exhausted.

: Replace with new battery. (→p.7)

•The table shows the number of 24-exposure rolls based on Canon’s tests with a new battery and an EF 50mm f/1.4 USM lens. Figures in parentheses are the number of 36-exposure rolls.

•Information on battery life with Power Drive Booster PB-E2 or E1 and Battery Pack BP-E1 is provided in the respective instruction booklet.

•If the < > is set to < > and nothing is displayed on the LCD panel, the battery may have been installed incorrectly. Take out the battery and install correctly. Then check the battery level again.

•Since actual shooting conditions may differ, the actual number of rolls may be less than the figures in the table.

•Pressing the shutter button halfway for prolonged periods or frequent autofocusing without taking any pictures will lower the number of rolls that can be taken.

•When the camera is not to be used, set the < > to < >. This will prevent accidental battery drainage if the shutter button is held down inadvertently.

•The battery level is indicated each time the < > is turned on. To check the current battery level, turn on the < > again.

20

Image 20

Canon EOS-1V HS manual Checking the Battery Level, Battery Life No. of Rolls, Turn the to

Contents

Instructions Page Thank you for purchasing a Canon product SymbolsPrecautions Contents Flash Photography For EOS-1V HS Users Handling Precautions Camera Care and Storage How Low Battery Levels Affect Camera Operation LCD DisplaysLithium Batteries Lens Electrical Contacts Nomenclature Side Door Buttons LCD Panel AEB Viewfinder Information Conventions Used in this Instruction Booklet Page Shutter Button Main SwitchBasic Operation Complete pressing Using the Electronic DialsHalfway pressing Page Reverting to the Default Settings There are three ways to use Open the side door, press the button, then press the button Resetting the camera to the default settingsOpen the side door and press the button Installing the Battery and Checking the Battery Level 2Open the cover Install the batteryRemove the grip Reattach the grip Turn the to Checking the Battery LevelBattery Life No. of Rolls Detaching the Lens Mounting and Detaching a LensMounting a Lens Dioptric Adjustment 2Turn the dioptric adjustment knobFilm ID Imprinting Remove the eyecup Press Button to set Film ID setting mode 2Turn the dial to set the desired user-settable No Press the shutter button halfway Loading and Unloading Film Loading FilmOpen the camera back Insert the film cartridge at an 4Close the camera back Setting the Film Speed Press the and buttons simultaneously Press the button 2Take out the film cartridge Unloading FilmMidroll Rewind 2Quick Start With Program AE Select on the LCD panel Focus the subject Shifting the Program Holding the Camera 3Using Autofocus AF AF Mode Selection Set the lens focus mode switch to AF 2Set the AF mode One-Shot AF for Still Subjects AI Servo AF for Moving Subjects About Predictive AF Area AF Ellipse and Focusing Points Focusing points in the Area AF ellipse Focusing Point Selection Basic Procedure for Focusing Point SelectionSelecting a horizontal focusing point Selecting a vertical focusing point Manual selection of 45 focusing points Automatic SelectionManual Selection Press the button and turn the dial Selecting a peripheral focusing point Manual selection limited to 11 focusing points C.Fn-13-1/2Manual selection limited to 9 focusing points C.Fn-13-3 Selecting the center focusing point Registering a Focusing Point Press the button which Switching to the Registered Focusing Point Press the button and button simultaneously Focusing Point Activation Area C.Fn-17 Focusing an Off-Center Subject AF Sensitivity According to the Lens Maximum Aperture When Autofocus Fails Manual Focusing Manual Focusing Set the lens focus mode switch to MF or M on older lenses Metering Modes Selecting a Metering Mode 2Release the button Metering Modes Evaluative MeteringPartial Metering Spot Metering Centerweighted Averaging Metering Focusing Point-Linked Spot Metering Multi-Spot Metering Multi-Spot Metering Display Fixed Metering mark Shooting Modes Shutter Speed-Priority AE Press the shutter button halfway and focus the subject Aperture-Priority AE Aperture-Priority AE If the 30 shutter speed blinks, it indicates underexposure Depth-of-field AE 6Take the picture Exposure Warnings Depth-of-field AE Using the Built-in Exposure Meter Manual Exposure 4Focus the subject 5Refer to the exposure level 4Take the picture Setting Exposure CompensationExposure Compensation with the Dial Exposure Compensation with the Button and Dial Autoexposure Bracketing 2Turn the dial to set the desired bracketing amount Canceling AEB Take the pictures AE Lock Recompose the shot and take the picture 3Release the two buttons Setting the Film Speed ManuallyPress and hold down the button and button simultaneously 3Set the shooting mode and take the pictures Multiple Exposure Exposure Compensation Guide for Multiple Exposures Bulb Exposures 3Start the bulb exposure 2Turn the dial to set the desired film advance mode Single-Frame and Continuous ShootingSingle-frame Shooting Continuous Shooting When , , , , or Blinks Maximum Continuous Shooting Rates Self-timer Operation 3Press the shutter button completely Using the Eyepiece Shutter Depth-of-field Preview Mirror Lockup Press the shutter button completely LCD Panel Illumination Using B/W Infrared Film2Use the infrared index to adjust the distance Flash Photography TTL autoflash High-Speed Sync FP FlashFE Flash Exposure Lock Flash exposure compensation 2Check that the 550EX’s pilot lamp is lit Take the picture Full Auto FlashTTL Autoflash in Other Shooting Modes High-Speed Sync FP Flash Part where you want to lock FE LockCheck that the Speedlite’s pilot lamp is lit Aim the spot metering circle over 4Compose the shot and take the picture 2Take the picture Flash Exposure CompensationDesired flash exposure compensation amount FEB Flash Exposure Bracketing Modeling Flash Wireless, Multi-Speedlite System Wireless, multi-Speedlite system Using Other EOS-Dedicated Speedlites PC Terminal Using Non-Canon Flash UnitsSync Speed Custom Functions Selecting and Setting a Custom Functions Custom Function No. appears on the LCD panel Canceling a Custom Function Canceling All Custom Functions4Press the shutter button halfway Open the side door and press the button. Then press Button Fn-1Auto film rewind mode Custom Function SettingsFn-0Focusing screen characteristics Fn-3DX-coded film speed setting method Fn-2Film leader position Fn-4AF activation/AE lock Fn-5Manual Tv/Av settings Fn-7USM lens electronic manual focusing Fn-6Exposure level increments Fn-8Frame counter sequence Fn-9AEB sequence and auto cancellation Fn-10Focusing point flashing mode Fn-11Focusing point selection method Fn-11-1This reverses the functions of the button and button Fn-12Mirror lockup Fn-14Automatic reduction of fill flash output Fn-15Shutter curtain synchronization Fn-16Safety shift Fn-17Focusing point activation area Fn-18Switchover to registered focusing point Fn-19Lens AF stop button function switching Personal Functions Personal Functions Custom Function Group Registration 2Press the button to set the Personal Function modeFn-0Custom Function Group Selecting a Custom Function Group Recording the Shooting Data Standard Shooting Data 8For EOS-1V HS Users Remove the battery magazine 2Install the batteries Ultra-high speed continuous shooting High-speed continuous shootingLow-speed continuous shooting Single-frame shooting Install a battery in the Grip GR-E2. →p.19 2Detach the Power Drive Booster PB-E2Attaching Grip GR-E2 Attach the Grip GR-E2 9Reference Section Basic Photography Terms ExposureShutter speed Aperture Depth of field Depth of field is affected as described below Troubleshooting Guide Film does Mode Blinking Warning Indication Countermeasures Exposure Warning List Program Line Program Line Description Aperture readout Shutter Speed and Aperture ReadoutsShutter speed readout Interchanging the Focusing Screen Open the side door and press 128 Major Accessories Ni-MH Charger NC-E2 Battery Pack BP-E1 EX-series Speedlites Anti-Fog Eyepiece Ec Series Dioptric Adjustment LensesDate Back DB-E2 Remote Switch RS-80N3 Wireless Controller LC-4 Major Specifications TypeViewfinder Exposure Control Autofocus AI Servo AF Tracks subject movement up to the start Shutter Film TransportFilm ID Imprinting w/standard camera back Shooting Data Camera Specifications EOS-1V Index 129 139 140 Memo 142 143