Canon qy8-13az-000 service manual

The remaining ink amount [1683] unknown.

Ink tank not recognized. [1684]

Ink tank not recognized. [1410 to 1419]

Scanning unit (printer	[1200]
cover) open.

(Applicable ink tank icon)

The remaining level of the following ink cannot be correctly detected. Replace the ink

tank. (U130)

The following ink tank cannot be recognized. (U140)

(Applicable ink tank icon)

The following ink tank cannot be recognized. (U150)

(Applicable ink tank icon)

Cover is open. Close cover.

-Fill in all the circles on the print head alignment sheet.

-Place the sheet in the correct orientation and position.

An ink tank which has once been empty is installed. Replace the applicable ink tank with a new one.

Printing with a once-empty ink tank can damage the printer.

To continue printing without replacing the ink tank(s), press the OK button for 5 sec. or longer to disable the function to detect the remaining ink amount. After the operation, it is recorded in the printer EEPROM that the function to detect the remaining ink amount was disabled.

A non-supported ink tank is installed (the ink tank LED is turned off). Install the supported ink tanks.

A hardware error occurred in an ink tank (the ink tank LED is turned off). Replace the ink tank(s).

Close the scanning unit (printer cover).

2-2. Service Call Errors (by Cyclic Blinking in Orange (Alarm LED) and Green (Power LED), or Both LEDs Lit)

Service call errors are indicated by the number of cycles the Alarm LED and Power LED blink, and the corresponding error code is displayed on the LCD.

Cycles of blinking				Solution
in orange (Alarm	Error	Error	Conditions
				(Replacement of listed parts, which
LED) and green		code
(Power LED)				are likely to be faulty)
2 times	Carriage error	[5100] An error occurred in the carriage encoder signal.		- Carriage unit (QM2-3753)
				- Timing slit film (QC1-9542)
				- Logic board (QM2-3827)
				- Carriage motor (QM2-3872)
3 times	Line feed error	[6000]	An error occurred in the LF encoder signal.	- Timing sensor unit (QM2-3878)
				- Timing slit disk film (QC1-9597)
				- Feed roller (QL2-1407)
				- Logic board (QM2-3827)
				- Paper feed motor (QM2-3873)
4 times	Purge cam	[5C00]	An error occurred in the purge unit.	- Purge unit (QM2-3754)
	sensor error			- Logic board (QM2-3827)
5 times	ASF (cam)	[5700]	This error takes place when feeding paper from the	- Sheet feed unit (QM2-3762)
	sensor error		ASF after an error occurred in the ASF cam sensor.	- ASF_PE sensor board (QM2-3877)
				- Logic board (QM2-3827)
6 times	Internal	[5400]	The internal temperature is not proper.	- Logic board (QM2-3827)
	temperature			- Carriage unit (QM2-3753)
	error
7 times	Ink absorber	[5B00,	The ink absorber is full.	- Ink absorber kit (QY5-0178)
	full	5B10,
		5B01,	Error codes:
		5B11]

Overseas:

5B00: Main ink absorber

5B10: Borderless-print ink absorber Japan:

5B01: Main ink absorber

1-5