2-9

Using the Setup Wizard

7.Press 6(DRAW) to graph the function.

•This graphs the function and displays a vertical cursor line as shown below. Use the graph to specify the range that you want to output to the speaker.

8.Use the d and e cursor keys to move the cursor to the start point of the output, and then press w to register it.

9.Use the d and e cursor keys to move the cursor to the end point of the output, and then press w to register it.

•After you specify the start point and end point, an output frequency dialog box shown below appears on the display.

/

10.Input a percent value for the output frequency value you want.

•To output the original sound as-is, specify 100%. To raise the original sound by one octave, input a value of 200%. To lower the original sound by one octave, input a value of 50%.

11.After inputting an output frequency value, press w.

•This outputs the waveform between the start point and end point from the EA-200 speaker.

•If the sound you configured cannot be output for some reason, the message “Range Error” will appear. If this happens, press J to scroll back through the previous setting screens and change the setup as required.

12.To terminate sound output, press the EA-200 [START/STOP] key.

13.Press w.

•This displays a screen like the one shown below.

20051101