11-13

Graph Analysis Tool Graph Screen Operations

3.Move the trace pointer to the end point of the range you want to output from the speaker, and then press w.

•After you specify the start point and end point, an output frequency dialog box shown below appears on the display.

/

4.Input a percent value for the output frequency value you want.

•The output frequency specification is a percent value. To output the original sound as-is, specify 100%. To raise the original sound by one octave, input a value of 200%. To lower the original sound by one octave, input a value of 50%.

5.After inputting an output frequency value, press w.

•This outputs the waveform between the start point and end point from the EA-200 speaker.

•If the sound you configured cannot be output for some reason, the message “Range Error” will appear. If this happens, press J to scroll back through the previous setting screens and change the setup as required.

6.To terminate sound output, press the EA-200 [START/STOP] key.

7.Press w.

•This displays a screen like the one shown below.

8.If you want to retry output from the speaker, press 1(Yes). To exit the procedure and return to the graph screen, press 6(No).

•Pressing 1(Yes) returns to the “Output Frequency” dialog box. From there, repeat the above steps from step 4.

20051101