Recording and Playing Audio

To repeat play a specific phrase

1.Perform steps 1 through 4 under “To play back a recorded audio file” (page E-126) to start playback.

2.When playback reaches the location you want to specify as the repeat start point, press the L-12 (REPEAT) button.

•This will display a screen like the one shown below, which shows the start point you specified (minutes:seconds) and the flashing ?indicator.

3.When playback reaches the location you want to specify as the repeat end point, press the L-12 (REPEAT) button again.

•This will immediately return to the start point you specified in step 2 and start repeat playback. At this time a screen like the one shown below showing the end point you specified (minutes:seconds) will be displayed first. After a few seconds, the display will change to the original audio play screen.

•The ?indicator will be on the display while repeat playback is in progress.

•The operations you can perform during repeat playback are the same as those that are supported during normal playback. For details, see step 4 under “To play back a recorded audio file” (page E-126).

4.To cancel repeat playback, first press the L-16 (PLAY/STOP) button to stop it. Next, press the L-12 (REPEAT) button.

•This causes the ? indicator to disappear from the display.

To rename an audio file

1.Press the C-6 (AUDIO PLAY) button to enter the audio play mode.

2.Use the dial or the R-14 (–, +) buttons to display the audio file number of the file you want to rename.

3.While holding down the R-13 (FUNCTION) button, press the C-17 (MENU) to display the audio play menu.

4.The 0should be next to “Rename”, so press the R-16 (ENTER) button.

•This displays the “Rename” screen.

5.Use the R-17 (u, i) buttons to move the cursor to the name character position you want to change, and then use the dial or R-14 (–, +) buttons to select the character you want.

•For details about the characters you can input, see “Supported Input Characters” (page E-160).

•To input a space, press both of the R-14(–, +) buttons at the same time.

6.Press the R-16 (ENTER) button.

7.In response to the “Sure?” message that appears, press the R-14 (YES) button to change the name or the R-14 (NO) button to cancel and return to the audio play screen.

•Pressing the R-15 (EXIT) button without pressing the R-14button will return to the screen in step 5 of this procedure.

E-128