Using a Memory Card

4. Use the R-17 (t, y) buttons to move the 0to

 

 

3. Depending on the type of data you want to save

 

“CardFormat”.

 

 

to the memory card, perform one of the steps

 

 

 

 

shown below.

 

 

 

 

 

• All setup registration banks are saved as a batch. Other

 

 

 

 

data is saved in area (data item) units.

 

 

 

 

 

 

 

 

 

 

 

To save this

 

Do this:

 

 

 

 

type of data:

 

 

 

 

 

 

 

 

 

 

 

One user rhythm

1.

Press the L-8 ([F] USER RHYTHMS)

 

 

 

 

 

 

button.

 

 

 

 

 

2.

Use the dial or R-14(–, +) buttons to

 

 

 

 

 

 

specify the user rhythm number.

 

 

 

 

 

 

 

5. Press the R-16 (ENTER) button.

 

 

One user tone

1.

Press the R-11 ([K] USER TONES)

 

 

 

 

button.

• This will display a value indicating the maximum

 

 

 

2.

Use the dial or R-14(–, +) buttons to

number of audio recordings that can be recorded.

 

 

 

 

specify the user tone number.

6. Use the dial or R-14 (–, +) buttons to specify the

 

 

One user

1.

Press the R-12 ([L] DRAWBAR ORGAN)

 

 

drawbar organ

 

button.

number of audio recordings you want to format

 

 

tone

2.

Use the dial or R-14(–, +) buttons to

the card for.

 

 

 

 

specify the user drawbar organ tone

• You can format a 2GB card for up to 14 songs. A 4GB

 

 

 

 

number (L:051 through L:100).

 

 

 

 

 

to 32GB card can be formatted for up to 20 songs.

 

 

One user DSP

1.

Perform steps 1 through 4 under “To use

• An audio recording area of approximately 128MB is

 

 

 

 

a DSP” (page E-32).

reserved on the memory card for each song.

 

 

 

2.

Use the dial or R-14(–, +) buttons to

• The minimum number of audio recordings you can

 

 

 

 

specify the user DSP number (101

 

 

 

 

through 200).

specify is 0 (which specifies the card will not be used

 

 

 

 

 

 

 

 

 

for storage of audio recordings).

 

 

One user preset

1.

While holding down the L-6 ([D] WORLD/

• The higher the number of audio recordings you specify

 

 

 

 

VARIOUS) button, press the L-7 ([E]

here, the longer it will take to format the card.

 

 

 

 

PIANO RHYTHMS) button to display the

7. Press the R-14 (YES) button to format the

 

 

 

 

music preset screen.

 

 

 

2.

Press the L-8 ([F] USER RHYTHMS)

memory card or the R-14 (NO) button to cancel.

 

 

 

3.

button.

• The message “Please Wait” will remain on the display

 

 

 

Use the dial or R-14(–, +) buttons to

 

 

 

 

specify the user preset number.

while the format operation is being performed. Do not

 

 

 

 

 

 

 

 

 

 

 

One song

1.

Press the C-4 (SONG SEQUENCER)

perform any Digital Keyboard operation while this

 

 

message is on the display. “Complete” appears on the

 

 

sequencer song

 

button to enter the song sequencer mode.

display after formatting is complete.

 

 

 

2.

Use the dial or R-14(–, +) buttons to

 

 

 

 

specify the song number.

• Formatting may take as long as a few minutes to

 

 

 

 

 

 

 

 

 

complete.

 

 

All registration

Press the C-10 (BANK) button to display the

 

 

 

 

banks

registration bank selection screen.

Saving Digital Keyboard Data to a

 

 

 

4. While holding down the R-13 (FUNCTION)

Memory Card

 

 

 

 

 

 

button, press the C-9 (LOAD/SAVE) button.

 

 

 

 

• This causes an “Xxxx Load”*1 screen like the one

To save Digital Keyboard data to a memory

 

 

shown below to appear. The sample screen below

card

 

 

shows the screen that appears from the rhythm screen.

 

 

 

 

 

 

 

 

 

 

 

 

1. Insert the memory card into the card slot.

 

 

 

 

 

2. If the Digital Keyboard is in the card mode,

 

 

 

 

 

press the C-9 (CARD) button to exit the card

 

 

 

 

 

mode.

 

 

 

 

 

 

 

 

 

 

 

 

E-138