|
|
|
|
|
| |
|
|
|
|
| Using the Song Sequencer | |
| Deleting Pitch Bender Events | ■ To delete all pitch bender events within a specific | ||||
| ||||||
| range of a track | |||||
|
|
|
| |||
You can use the procedures in this section to delete all pitch | ||||||
1. Display the event editor screen of the track | ||||||
bender events from a track or from a specific range in a track. | ||||||
|
|
|
| whose pitch bender events you want to delete. | ||
|
|
|
| • | See “To select a track for editing” (page | |
|
|
|
| |||
|
|
|
| |||
• | To delete individual pitch bender events, perform the | |||||
2. If required, you can perform a song playback | ||||||
|
| operation under “To delete an individual event” (page | ||||
• | operation at this time to check the range you | |||||
After deleting the pitch bender events in one track from | want to select for deletion. | |||||
|
| Track 01 through Track 16, you can overdub new pitch | ||||
|
| • See “To play back a song from the event editor screen | ||||
|
| bender (PITCH BEND wheel | ||||
|
|
| (Quick Play)” (page | |||
|
| track. To do so, use the procedure under “To record to |
| |||
|
|
|
| |||
|
| Tracks 01 through 16” (page | 3. While holding down the | |||
|
| (Overdub) for the “RecType” setting in step | ||||
|
| button, press the | ||||
• Since “OVDB” cannot be selected for “RecType” when | ||||||
the event editor menu. | ||||||
|
| recording to the system track, you will not be able to | ||||
|
| overdub pitch bender operations after deleting pitch bender | 4. Use the | |||
|
| events from the system track. You can use the procedure | ||||
|
| under “To insert an event” (page | “DeleteBender” and then press the | |||
|
| bender events. | (ENTER) button. | |||
■ To delete all pitch bender events in a track | • | This causes “Delete Bender” screen to appear. | ||||
|
| |||||
1. Display the event editor screen of the track | 5. Use the dial or | |||||
setting in the thick brackets (%) to “Locator”. | ||||||
|
| whose pitch bender events you want to delete. | ||||
|
| • | This displays a range specification screen like the one | |||
|
| • See “To select a track for editing” (page | ||||
|
|
| shown below. | |||
2. While holding down the |
| |||||
• | If you have already specified a range using the locator | |||||
|
| button, press the |
| screen (page | ||
|
|
| range specification screen. | |||
|
| the event editor menu. |
| |||
|
|
|
|
3.Use the
•This causes “Delete Bender” screen to appear.
|
| Range start point | Range end point | |
| 6. | Use the | ||
|
| cursor, and then use the dial or | ||
|
| buttons to change the value at the cursor | ||
4. Use the dial or |
| position. |
| |
setting in the thick brackets (%) to “ALL”, and | 7. | After everything is the way you want, press the | ||
then press the |
|
| ||
|
|
| ||
5. In response to the “Sure?” message that | 8. | In response to the “Sure?” message that | ||
appears, press the | ||||
| appears, press the | |||
or the |
| |||
| or the | |||
|
|