Using the Mixer

Mixer Parameter Settings

The tables below show the parameters that can be configured on the mixer screen.

The settings marked with an asterisk (*) in the “Setting Range” column are initial defaults.

MASTER Parameters

MASTER parameters include items for adjusting the volume level, pan position, and other settings that are applied globally to all parts.

Parameter Name

Description

Setting Range

Volume

Specifies the maximum volume level of Digital Keyboard output.

0 to 127*

(Master Volume)

The level set here is the maximum level that can be set with the L-2 (VOLUME)

 

 

knob.

 

 

 

 

Pan

Specifies the stereo pan position of all sound output by the Digital Keyboard.

–64 to 0* to +63

(Master Pan)

0 indicates the center, while a smaller values shifts to the left and a larger value

 

 

shifts to the right.

 

 

 

 

DSP Parameters

DSP parameters include DSP-related settings that are applied globally to all parts.

•DSP parameter setting cannot be changed while “on” is selected for the “DSP Disable” effect setting. See “To add the chorus effect to sounds” (page E-31) for information about “DSP Disable”. If you want to change DSP parameter settings, change the “DSP Disable” setting to “oFF”.

Parameter Name

Description

Setting Range

Cho/DSP

Specifies whether the Digital Keyboard’s sound source should go through

Chorus*, DSP

(Chorus/DSP)

the chorus or DSP.*1 This setting item is linked to the “Chorus/DSP”*2 item

 

 

on the effect setting screen. The settings below cannot be configured

 

 

whenever this parameter is “Chorus”.

 

 

 

 

Part

Specifies if a note should be output (on) or not output (oFF) after it passes

oFF, on*

(DSP Output Enable)

through the DSP.

 

 

 

 

Volume

Specifies the post-DSP volume level.*1

0 to 127*

(DSP Output Volume)

 

 

 

 

 

Pan

Specifies the post-DSP send stereo pan position. 0 indicates the center,

–64 to 0* to +63

(DSP Output Pan)

while a smaller values shifts to the left and a larger value shifts to the right.

 

 

 

 

Rev.Send

Specifies how much reverb is applied to the post-DSP send note.

0 to 40* to 127

(DSP Output Reverb Send)

 

 

 

 

 

*1 See the block diagram under “Configuration of Effects” (page E-29).

*2 See “To add the chorus effect to sounds” (page E-31) and “To use a DSP” (page E-32).

E-41