Applying Effects to a Sound

5. Use the R-17 (t, y) buttons to move the 0to

10. Use the dial or R-14 (–, +) buttons to select the

the parameter you want to change.

destination user DSP number you want.

 

11. Use the R-17 (u, i) buttons to move the

 

cursor to the name character position you want

 

to change, and then use the dial or R-14 (–, +)

 

buttons to select the character you want.

 

•

See “Supported Input Characters” (page E-160) for

 

 

information about the characters you can input for the

 

 

name.

 

•

To input a space, press both of the R-14(–, +) buttons

• For information about the operation and the setting

 

at the same time.

 

 

range of each parameter, see “DSP Parameter

12. After everything is the way you want, press the

Settings” (page E-35).

R-16 (ENTER) button.

6. Use the dial or R-14 (–, +) buttons to change the

•

A message (Replace?) will appear on the display to

setting value.

 

confirm whether you want to replace the existing data

• Pressing the R-14(–, +) buttons at the same time

 

with the new data. Press the R-14 (YES) button to

 

replace the existing data with the new data.

returns a parameter to its initial default setting.

 

 

 

• Changing the DSP parameter while a note is being

 

 

output from the Digital Keyboard may cause noise to be

 

 

 

 

generated. This does not indicate malfunction.

• The message “Please Wait” will remain on the display

7. Repeat steps 5 and 6 as required to configure

while a data save operation is in progress. Do not

perform any other operation while it is displayed.

other parameters.

Turning off the Digital Keyboard or removing the

8. Press the R-15 (EXIT) button.

memory card can cause Digital Keyboard data to be

deleted or become corrupted. It also can cause the

• This displays the confirmation screen shown below.

Digital Keyboard to fail to turn on when the L-1

 

(POWER) button is pressed. If this happens, refer to

 

“Troubleshooting” (page E-150).

To cancel the editor operation without saving the edited results, press the R-14 (NO) button.

9.Press the R-14 (YES) button.

•This displays a screen for specifying the destination user DSP number and DSP name.

Destination user DSP number

DSP name

E-34