Casio CTK-7200, WK-7600 manual 17

	Selecting and Playing a Tone
5. Now you can play on the keyboard using the	• Three tones, two layered tones for the right range and
tone you selected.	one tone for the left range of the keyboard (page E-17)
	This configuration uses the UPPER 1 part, UPPER 2 part,
	and LOWER part (Layer: On, Split: On).
• You also can use the R-14(–, +) buttons to select a tone.
Holding down either button will scroll through tone numbers
at high speed. Pressing both of the R-14(–, +) buttons at
the same time will select tone 001 in the currently selected		UPPER 1
group.	LOWER
		UPPER 2
Layering and Splitting Tones
You can configure the keyboard to play two different tones at	• You can configure the settings described below to adjust
the same time (Layer) or to play different tones in the left and
right ranges (Split). You can even use Layer and Split in	each part when using multiple tones in layer and split
combination with each other and play three different tones at	configurations.
the same time.	To adjust this setting for	Go here for more
The UPPER 1 part is used alone when playing an individual
	each part:	information:
tone on the keyboard. When layering two tones, the UPPER 1
	Octave shift	Using Octave Shift
part and UPPER 2 parts are used. When splitting the
		(page E-18)
keyboard between two tones, the low range of the keyboard
plays the LOWER part.	Volume balance	Using the Mixer (page E-36)
• One tone across the entire keyboard (page E-14)	Stereo position, effect
	(reverb, chorus) levels, and
This configuration uses the UPPER 1 part only (Layer: Off,
	other detailed settings
Split: Off).

UPPER 1

•Two layered tones across the entire keyboard (page E-16)

This configuration uses the UPPER 1 part and UPPER 2 part (Layer: On, Split: Off).

UPPER 1

UPPER 2

•Two tones, one for the left range and one for the right range of the keyboard (page E-17)

This configuration uses the UPPER 1 part and LOWER part (Layer: Off, Split: On).

LOWER UPPER 1

E-15