Cisco Systems 11.0 BT manual Dlur SAP Configuration Mode, PU Configuration Mode

TN3270 Configuration Modes

DLUR SAP Configuration Mode

From DLUR server configuration mode, lsap command puts you in DLUR SAP configuration mode.

Prompt:

tn3270-dlur-lsap>

PU Configuration Mode

There are two paths to PU configuration mode: from the TN3270 server configuration mode, or from the DLUR configuration mode. In either mode, the pu command puts you in PU configuration mode.

From TN3270 configuration mode, the pu command to create a new PU is:

pu pu-name idblk-idnum ip-address type adapno lsap [rmac rmac] [rsap rsap] [lu-seedlu-name-stem]

From DLUR configuration mode, the pu command to create a new PU is:

pu pu-name idblk-idnum ip-address

From either mode, to return to PU configuration mode on PU pu-name the command is:

pu pu-name

Prompts:

tn3270-pu> tn3270-dlur-pu>

Commands Allowed in Multiple Modes

The following commands are valid in TN3270 configuration mode, or in either variation of PU configuration mode:

[no] tcp-port port-number

[no] idle-time seconds

[no] keepalive seconds

[no] unbind-action {keep disconnect}

[no] generic-pool {permit deny}

[no] shutdown

Values entered in PU configuration mode override settings made in TN3270 configuration mode. In addition, the no form of these commands entered in PU configuration mode will restore the command value entered in TN3270 command mode.

12Configuring TN3270 Server on the Channel Interface Processor