Cisco Systems 11.0 BT manual Fail number, Number, Dlur fq-cpname, Dlus fq-dlusname, Name pu-name

show extended channel tn3270-server

Table 5 Show tn3270-server Field Descriptions (Continued)

Field	Description
DISCONN number	Total number of disconnects since the TN3270 feature was started.
FAIL number	Total number of failed connects since the TN3270 feature was
	started.
RESPONSE TIME, HOST	The average response time from the host across all sessions through
number	this server IP address. This is measured from sending CD to the
	host to receiving the reply.
RESPONSE TIME, TCP	Average response time from the clients on this server IP address.
number	This is measured only when TIMING MARKs are sent. If no
	timing-markis configured, they are only sent on special occasions,
	such as Bind.
IDLE-TIME number	Configured idle-time for this PU.
KEEPALIVE number	Configured keepalive for this PU.
UNBIND-ACTION type	Configured unbind action for LUs on this PU.
TCP-PORT number	Configured TCP port number.
GENERIC-POOL type	Configured generic-pool for LUs on this PU.
DLUR fq-cpname	Configured fully qualified DLUR CP name.
STATUS	Possible DLUR-DLUS status values and their meanings are:
	reset—The DLUR-DLUS pipe is reset.
	pnd-actv—The DLUR-DLUS pipe is pending active.
	active—The DLUR-DLUS pipe is active.
	pnd-inac—The DLUR-DLUS pipe is pending inactive.
DLUS fq-dlusname	Currently active DLUS.
NAME pu-name	This is the name of the PU as configured.
IP:TCP ip-addr:tcpport	IP address and TCP port number configured for the PU.
XID number	Configured XID - idblk and idnum.
STATE value	Possible STATE values and their meanings are:
	•	shut—The PU is configured but in shut state.
	•	reset— The link station of this PU is not active.
	•	test—PU is sending a TEST to establish link.
	•	xid—TEST is responded, XID is sent.
	•	p-actpu—The link station is up but no ACTPU is received.
	•	active—ACTPU is received and acknowledged positively.
	• act/busy—Awaiting host to acknowledge the SSCP-PU data.
	•	wait—Waiting for PU status from CIP.
	•	other—PU in undefined state.
	• p-rqactpu-r—DLUR PU is pending request ACTPU response.
	• p-active—ACTPU received by DLUR but not yet passed to PU.
	• p-dactpu—PU is pending DACTPU.

TN3270 Server Commands 37