Cisco Systems 11.0 BT manual Configure Dlur, Configure SAPs under Dlur

TN3270 Configuration Task List

Task	Command
(Optional) Specify the idle time for server	idle-timenum-of-seconds
disconnect. This command is also available in
TN3270 configuration mode.
(Optional) Specify the maximum time allowed	keepalive num-of-seconds
between keepalive marks before the server
disconnects. This command is also available in
TN3270 configuration mode.
(Optional) Specify whether the TN3270 session	unbind-action{keep disconnect}
will disconnect when an UNBIND command is
received. This command is also available in
TN3270 configuration mode.
(Optional) Select whether “left-over” LUs can be	generic-pool {permit deny}
used from a generic LU pool. This command is also
available in TN3270 configuration mode.

When you use the pu command, you enter PU configuration mode and can use all other commands in this task list. Configuration values you enter in PU configuration mode will override other values entered while in TN3270 configuration mode. In addition, you can enter PU configuration mode from DLUR configuration mode when configuring PUs that are connected by means of DLUR.

If you are configuring PUs for directly connected hosts, you need not perform any additional configuration tasks.

Configure DLUR

This task is required when configuring DLUR connected hosts. To configure DLUR parameters for the TN3270 server, perform the following tasks beginning in TN3270 configuration mode.

Task	Command
Create a DLUR function in the TN3270 server and	dlur fq-cpname fq-dlusname
enter DLUR configuration mode.
(Optional) Specify the fallback choice for the	dlus-backup dlusname2
DLUR DLUS.
(Optional) Specify the preferred network node	preferred-nnserver NNserver
(NN) server.

Configure SAPs under DLUR

To configure SAPs under the DLUR function, perform the following tasks beginning in DLUR configuration mode.

Task	Command
Create a SAP function under DLUR and enter	lsap type adapno [lsap]
DLUR SAP configuration mode.
(Optional) Identify an APPN virtual routing node	vrn vrn-name
(VRN).

Configuring TN3270 Server on the Channel Interface Processor 15