Update to Command Reference

Update to Command Reference

The information that follows is an update to the Router Products Command Reference, Chapters 23 to 33. Add the TN3270 information as a standalone chapter following page 33-30.

TN3270 Server Commands

This update describes the commands to configure TN3270 support on the Channel Interface

Processor (CIP). For TN3270 configuration tasks and examples, refer to the “Configuring TN3270

Server on the Channel Interface Processor” update chapter of this Release Note.

The following commands are documented in this update chapter:

dlur, page 20

dlus-backup, page 21

generic-pool, page 22

idle-time, page 24

keepalive, page 25

link, page 26

lsap, page 28

maximum-lus, page 30

preferred-nnserver, page 31

pu (DLUR), page 35

pu (direct), page 32

show extended channel tn3270-server, page 36

show extended channel tn3270-server client-ip-address, page 39

show extended channel tn3270-server dlur, page 42

show extended channel tn3270-server dlurlink, page 44

show extended channel tn3270-server pu, page 45

show extended channel tn3270-server pu lu, page 48

shutdown, page 51

tcp-port, page 52

tn3270-server, page 54

timing-mark, page 53

unbind-action, page 55

vrn, page 56

TN3270 Server Commands 19

Page 19
Image 19
Cisco Systems 11.0 BT manual Update to Command Reference