Cisco Systems 3200 Series manual Reattaching the Antenna End Cap

Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure

Card Replacement Process

Reattaching the Antenna End Cap

To reattach the antenna end cap, follow these steps:

Step 1 If you have added one or more WMICs, remove two of the corresponding plugs from the antenna end cap and replace them with RP-TNC connectors.

Step 2 Attach the antenna cables to the antenna end cap, as shown in Figure 2-2.

Step 3 Attach the identification labels for the antennas to the antenna end cap.

Step 4 Use a 3/8-inch socket wrench to secure the antenna end cap with 4 1/4-20x1.25-inch-long bolts. The torque range for the antenna end cap bolts are 58 to 68 in-lb.

Applying New I/O End Cap Function Labels

To apply new I/O end cap function labels, follow these steps:

Step 1 Label the WMIC console ports.

Step 2 If you have more than one WMIC installed in the router, remove the W2 plate on the I/O end cap and replace it with the DB-9 console connector.

	Cisco 3200 Series Router Hardware Upgrade Guide
OL-15983-01		2-19