Cisco Systems 4500 manual Feature Description

Chapter 1 Product Overview

Switch Features

Table 1-4	Features of the Catalyst 4510R Switch (continued)
Feature		Description
Supervisor engine		• Supports the Supervisor Engine V, V-10GE, 6-E
support		Note The blank line card (C4K-SLOT-CVR-E) must be installed when either
		of the following two situations occur:
		If your Catalyst 4507R or Catalyst 4510R switch chassis has a
		Supervisor Engine 6-E (WS-X45-SUP6-E) or a Supervisor Engine 6L-E
		(WS-X45-SUP6L-E) installed in slot 1 and slot 2 is empty, you must
		install the blank line card (C4K-SLOT-CVR-E) in slot 2 rather than a
		blank faceplate (C4K-SLOT-CVR) . A blank faceplate covering the slot 2
		opening does not direct sufficient airflow to adequately cool the
		Supervisor Engine 6-E or Supervisor Engine 6L-E.
		If your Catalyst 4507R or Catalyst 4510R switch chassis has a
		Supervisor Engine 6-E (WS-X45-SUP6-E) or a Supervisor Engine 6L-E
		(WS-X45-SUP6L-E) installed in slot 2 and slot 1 is empty, you must
		install the blank line card (C4K-SLOT-CVR-E) in slot 1 rather than a
		blank faceplate (C4K-SLOT-CVR) . A blank faceplate covering the slot 1
		opening does not direct sufficient airflow to adequately cool the
		Supervisor Engine 6-E or Supervisor Engine 6L-E.
		• Holds the ASIC-based forwarding engine (data path) and the management
		processor and software (control path)
		• Features interface monitoring, environmental status, and SNMP and
		console/Telnet interface
		Note With a single supervisor, packets are not forwarded while the module is
		removed; a system reboot occurs when a supervisor engine is reinserted.
		In redundant systems, removing the active supervisor causes the standby
		supervisor to become active.

	Catalyst 4500 Series Switches Installation Guide
78-14409-08		1-17