Cisco Systems 7912G, 7902G, 7905G manual Profile File Parameters, Udptos

Appendix A Additional Configuration Methods, Parameters, and Procedures

Configuration Parameters

Table A-3 Audio Parameters (continued)

Parameter	Description	Usage
ConnectMode	Connection mode of the	Bit map, as follows:
	protocol used by the	• Bit 0–29—Reserved for future use. Must be set
	Cisco IP Phone.
		to 0.
		• Bit 30 (mask 0x40000000)—If 1, enable
		Cisco IOS Telephony Solution (ITS) support to
		handle the differences between
		Cisco CallManager and Cisco ITS. Cisco ITS
		runs on an IOS router and is a subset of
		Cisco CallManager. If you have Cisco ITS, refer
		to the documentation for that product.
		• Bit 31 (mask 0x80000000)—If 1, enable
		downloading and processing of .cnf.xml
		configuration file information sent by
		Cisco CallManager.
NumTxFrames	Not used.
UDPTOS	UDP1 IP ToS2. Determines	Bit map value.
	the precedence and delay of	Use only the lower 8 bits. Upper bits should be set to
	sent IP packets.	0.
		The default setting is 0xB8.
MediaPort	Port number where the	Enter an even number from 0 to 65535. Each
	Cisco IP Phone sends and	connection uses the next available even-numbered
	receives RTP streams.	port for RTP.
		If set to 0, use the default value.
		The default setting is 16384.

1.UDP = User Datagram Protocol

2.ToS = type of service

Profile File Parameters

Table A-4describes the parameters that you can configure through a phone’s profile file only.

	Cisco IP Phone Administration Guide for Cisco CallManager 3.3, Cisco IP Phones 7902G/7905G/7912G
A-20	OL-6313-01