Appendix B Technical Specifications
SFP Transceiver Specifications
Connection Guidelines for AC-Powered Systems
For connecting the Cisco MDS 9100 Series switch AC power supplies to the site power source, follow these basic guidelines
•Each power supply should have its own dedicated branch circuit.
•For international, circuits should be sized according to local and national codes.
•The AC power receptacles used to plug in the chassis must be the grounding type. The grounding conductors that connect to the receptacles should connect to protective earth ground at the service equipment.
SFP Transceiver Specifications
The Cisco MDS 9100 Series is compatible with SFP transceivers and cables that have LC connectors. Each transceiver must match the transceiver on the other end of the cable in terms of wavelength, and the cable must not exceed the stipulated cable length for reliable communications.
Cisco SFP transceivers provide the uplink interfaces, laser transmit (TX), and laser receive (RX), and they support 850 to 1610 nm nominal wavelengths, depending upon the transceiver.
Use only Cisco SFP transceivers on the Cisco MDS 9100 Series. Each Cisco SFP transceiver is encoded with model information that enables the switch to verify that the SFP transceiver meets the requirements for the switch. For the list of supported SFP transceivers, see the release notes.
This section provides the following information:
•Cisco Fibre Channel SFP Transceivers, page
•Cisco Gigabit Ethernet/Fibre Channel Transceivers, page
•Cisco CWDM SFP Transceivers, page
For information about safety, regulatory, and standards compliance, see the Regulatory Compliance and Safety Information for the Cisco MDS 9000 Family.
Cisco Fibre Channel SFP Transceivers
Table
Cisco MDS 9124 Switch.
Table
Part Number | Description | Type |
|
|
|
Short wavelength | ||
| wavelength SFP |
|
|
|
|
Long wavelength | ||
| wavelength SFP |
|
|
|
|
| Long wavelength | |
| wavelength SFP |
|
|
|
|
Cisco MDS 9100 Series Hardware Installation Guide
|
| ||
|
|
