Cisco Systems OL-1089-11 manual 001/1111/31 Normal, unspecified-used to report a normal

Chapter 1 Billing Interfaces

CDE Detail Description

Table 1-53	Cause Information Element/Parameter Definitions (continued)
Cause			Application	Reference	Location
Class/Value/No.		Definition	(Note 1)	(Note 2)	(Note 3)	Remarks
001/1111/31		Normal, unspecified—used to report a normal	DSS 1, ISUP	Q.931	RLN
		event only when no other cause in the normal
				In Q.764, the	TN, INTL,	Call failure
		class applies.
				following	RLN	information
				sections:		indicating the
				2.1.1, 2.1.2,		failure of a call
						due to the lapse
				2.8.1, 2.8.2,
						of a timeout or
				2.9.3, 2.9.6,
						a fault not
				2.9.8.2,
						covered by
				2.9.8.3,
						specific causes
				2.1.8, 2.2.4
						(for example,
						expiry of
						timers Q.764
						not covered by
						specific causes,
						release of
						interconnected
						circuit, etc.)
				2.1.6/Q.764	RLN, TN	Expiry of
				2.9.7/Q.764		waiting INF
						timer (T33)
				Annex A/
				Q.763
010/0010/34		No circuit/channel available—indicates that	DSS 1, ISUP	Q.931,	U, RPN,
		there is no appropriate circuit/channel		Q.733.3	RLN, LN,
		presently available to handle the call.			TN
					TN, INTL	Circuit
						congestion
						encountered in
						an exchange
010/0110/38		Network out of order—indicates that the	DSS 1, ISUP	Q.931	U. RPN
		network is not functioning correctly and that
		the condition is likely to last a relatively long
		period of time (for example, immediately
		re-attempting the call is not likely to be
		successful).
010/0111/39		Permanent frame mode connection out of	DSS 1	Q.933
		service—included in a STATUS message to
		indicate that a permanently established frame
		mode connection is out of service (for
		example, due to equipment or section failure)
		(see Annex A/Q.933).

Cisco Media Gateway Controller Software Release 9 Billing Interface Guide

OL-1089-11 1-81