Cisco Systems OL-1089-11 manual Call Recovered Indication Tag, Partial Calling Line Identity Tag

Chapter 1 Billing Interfaces

CDE Detail Description

Call Recovered Indication (Tag: 4219)

Table 1-163	Call Recovered Indication Description Form
Name: Call Recovered Indication		Tag: 4219	Source: MDL

Description/Purpose: Indicates that the call was recovered by the standby MGC host following an automatic switchover and may have been released.

Format: BE		Length in Octets: 1
Data Value:
1	= Call Recovered
2	= Call Recovered and Released

Extended Data Value: No extended value.

General Information: Non-IN calls are recovered by the standby MGC host and continue normally following an automatic switchover. IN Calls are recovered by the standby MGC host but are then released gracefully. This tag is used to record either of these events. This tag is not included in the CDB for normal calls (that is, not recovered).

MGC Release: Release 9.5(2) and later.

Partial Calling Line Identity (Tag: 4220)

Table 1-164	Partial Calling Line Identity Description Form
Name: Partial Calling Line Identity (PCLI)		Tag: 4220	Source: MDL

Description/Purpose: The Partial Calling Line Identity, being sent out on-line by the MGC, is recorded in this tag. This value is generated by MGC in case CLI information is not received from the incoming call.

Format: Hexidecimal Length in Octets: 9

Data Value:

It holds the Partial CLI parameter content, which has the following format:

Type of Switch (0-99)

PNO Identity (0-999)

Switch Number(0-999)

For bilateral agreement

For bilateral agreement

For bilateral agreement

For bilateral agreement

For bilateral agreement

The “For bilateral agreement” octets contain either the IP address or the trunk group and member of the incoming call.

Extended Data Value: No extended value.

General Information:

MGC Release: Release 9.5(2) and later.

	Cisco Media Gateway Controller Software Release 9 Billing Interface Guide
1-144	OL-1089-11