Cisco Systems OL-19806-03 manual Debug energywise endpoint management, Endpoint, Management

Chapter 3 EnergyWise CLI Commands

debug energywise

debug energywise

To enable debugging of EnergyWise end points and managment stations, use the debug energywise command in privileged EXEC mode.

debug energywise {endpoint management}

Syntax Description	endpoint	Display information about EnergyWise end points running a client or agent.
	management	Display information about EnergyWise management stations running power
		management applications.
Command Default	EnergyWise debugging is disabled.
Command Modes	Privileged EXEC
Command History	Release	Modification
	12.2(53)SE1	This command was introduced on the Catalyst 3750-E, 3750, 3560-E, 3560, and 2960
		switches.
	12.2(54)SG	This command was introduced on Catalyst 4500 switches.
	12.2(33)SXI4	This command was introduced on the Catalyst 6500 switches. See the Cisco IOS
		Release Notes for Cisco EnergyWise, EnergyWise Phase 2 for the specific devices.
	15.0(1)M2	This command was introduced on Cisco Integrated Service Routers Generation 2
		(ISR G2), including Cisco 3900, 2900, and 1900 ISRs.
	The undebug energywise command is the same as the no debug energywise command.
Usage Guidelines
	When you enable debugging on a stacking-capable switch, it is enabled only on the stack master. To
	enable debugging on a stack member, use the session switch-numberprivileged EXEC command to start
	a session from the stack master. Enter the debug command on the stack-member command-line prompt.
	You can also use the remote command stack-member-number LINE privileged EXEC command on the
	stack master to enable debugging on a member switch before you start a session.
Related Commands	Command		Description
	show energywise neighbors		Displays the EnergyWise neighbor tables.

Cisco EnergyWise Configuration Guide

OL-19806-03 3-3