Cisco Systems OL-19806-03 manual Energywise domain, Security, Ntp-shared-secret, Protocol udp port

Chapter 3 EnergyWise CLI Commands

energywise domain

energywise domain

To enable EnergyWise on an entity, assign the entity to a domain, set the domain security mode, and set the domain password, use the energywise domain command in global configuration mode . To disable EnergyWise and to remove the EnergyWise configuration, use the no form of this command.

energywise domain domain-namesecurity {ntp-shared-secret shared-secret} [0 7] shared-secret[protocol udp port udp-port-number[interface interface-idip ip-address]]

no energywise domain

Syntax Description		domain domain-name	Assign the entity to a domain with the specified domain-name.
			• You can enter alphanumeric characters and symbols such as #, (, $, !, and
			&.
			• Do not enter an asterisk (*) or a blank space between the characters or
			symbols.
		security	Sets the domain security mode and the domain password to authenticate all
		{ntp-shared-secret	communication in the domain.
		shared-secret} [0 7]	• ntp-shared-secret—Uses a strong password with Network Time
		domain-password
			Protocol (NTP). If the time between members varies ±30 seconds, the
			entity drops events.
			• shared-secret—Sets a strong password without NTP.
			• (Optional) 0—Uses an unencrypted password.
			• (Optional) 7—Uses a hidden password.
			If you do not enter 0 or 7, the default is 0.
			• For the domain-password
			– You can enter alphanumeric characters and symbols such as #, (, $,
			!, and &.
			– Do not enter an asterisk (*) or a blank space between the characters
			or symbols.
		protocol udp port	(Optional) Specifies UDP as the communication protocol, and specifies the
		udp-port-number	UDP port that communicates with the domain.
			The range is from 1 to 65000.
		interface interface-id	(Optional) Specifies the port that communicates with the domain if the IP
			address is dynamically assigned.We recommend that you specify the
			interface-id. You should use this in a bridged network.
		ip ip-address	(Optional) Specifies the IP address that communicates with the domain if the
			interface is a switched virtual interface (SVI) and VLAN trunking protocol
			(VTP) pruning is enabled. You should use this in a routed network.
Command Default		EnergyWise is disabled, and the entity is not assigned to a domain.
		The domain password is not set.
		The udp-port-number is 43440.
			Cisco EnergyWise Configuration Guide
	OL-19806-03			3-13