Cisco Systems OL-19806-03 manual Absolute

Chapter 3 EnergyWise CLI Commands

energywise (interface configuration)

Usage Guidelines Before using the energywise activitycheck command, see the “Using the Call In-Progress Feature” section in the “Managing Single Entities” chapter.

If you enter the no energywise level command, the switch does not immediately change the power level to the default. The power level changes when the switch restarts or when you enter the energywise level level command.

For a recurring event, to configure multiple dates and times using the cron format (minute hour day_of_month month day_of_week)

•Use a comma (,) to specify a list of values without spaces between the values, for example, 1,3,4,7,8.

•Use a dash (-) to specify a range of values, for example, 1-6(same as 1,2,3,4,5,6).

•Use an asterisk (*) for a wildcard.

•Use a slash (/) to skip a specific number of values. For example

–Enter */15 * * * * for the event occurs every 15 minutes.

–Enter 0-59/3 * * * * or 0,20,40 for the event to occur every 20 minutes.

–Enter */61 * * * * for the event to occur every hour.

–Enter * */3 * * * or 0,3,6,9,12,15,18,21 for the event to occur every three hours.

For information about specifying the day_of_month and the day_of_week in the energywise level level recurrence importance importance at minute hour day_of_month month day_of_week command, see the “Configuration Guidelines” section in the “Managing Single Entities” chapter.

Examples		This example shows how to enable and configure EnergyWise on a port and how to configure a recurring
		event.
		Switch# configure terminal
		Enter configuration commands, one per line. End with CNTL/Z.
		Switch(config)# service password-encryption
		Switch(config)# energywise domain cisco security shared-secret cisco protocol udp port
		43440 ip 2.2.4.30
		Switch(config)# time-range onfirstfloor
		Switch(config-time-range)#absolute start 0:00 1 August 2009
		Switch(config-time-range)# periodic weekdays 6:00
		Switch(config-time-range)# periodic weekend 9:00
		Switch(config)# time-range offfirstfloor
		Switch(config-time-range)#absolute start 0:00 1 August 2009
		Switch(config-time-range)# periodic weekdays 20:00
		Switch(config-time-range)# periodic weekend 18:00
		Switch(config)# interface gigabitethernet0/3
		Switch(config-if)#energywise level 10 recurrence importance 70 time-range onfirstfloor
		Switch(config-if)#energywise level 0 recurrence importance 70 time offfirstfloor
		Switch(config-if)#energywise name floor.1
		Switch(config-if)#energywise role pc-mgr
		Switch(config-if)# end
Related Commands		Command	Description
		absolute	Sets a specific time and day for a recurring event.
		show energywise	Displays the EnergyWise settings and status.
		show energywise domain	Displays the domain to which the entity belongs.
		show energywise recurrences	Displays the recurring-event settings and status.
			Cisco EnergyWise Configuration Guide
	OL-19806-03			3-11