Cisco Systems PGW 2200 Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher Releases

3-3
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Chapter 3 Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher
Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher Releases
Installing the Cisco PGW 2200 Softswitch Software Release 9.8
and Higher Releases
Note Before you begin this procedure, the Solaris 10 operating system and Solaris 10 operating environment
should be already installed on your system.
Note Remove /usr/ucb from the path environment variable before the initial installation of the
Cisco PGW 2200 Softswitch software. However, if /usr/ucb is needed, make sure that it is located in the
path variable in the user profile after /usr/sbin.
Note In order for you to enable the SIP Improved Failover Support feature, both Cisco PGW 2200 Softswitch
systems must be in the same Virtual LANs (VLANs). A trunk line between the two switches must be
connected and configured for the SIP Improved Failover Support feature to work. However, if SIP
Improved Failover Support is not required on your system, then the trunk line is not mandatory.
Installing Cisco PGW 2200 Softswitch Software on a Simplex System
To install the Cisco PGW 2200 Softswitch software, complete the following steps:
Step 1 Log in as root.
Step 2 Load the Cisco PGW 2200 Softswitch software CD into the CD-ROM drive.
Step 3 Enter the following commands:
# cd /cdrom/cdrom0
# ./install.sh
The following prompt is displayed:
Use supplied admin file for unattended install? [n] [y,n,?,q]
Step 4 Enter y to perform an unattended installation. If you answer n, you must answer prompts and press Enter
for each package that is installed.
The following prompt is displayed:
Base directory for Toolkit (default /opt/Toolkit) [?,q]
Step 5 Press Enter to accept the default directory for the Toolkit.
Text similar to the following is displayed:
##########################################################################################
# The CSCOgu000 utilities package must be installed prior to other components #
# but has not been detected on your system. This package contains all required system #
# parameters necessary for installing the rest of your software. If you do not install #
# this package, the installation script will exit. #
##########################################################################################
Would you like to install it now? [y] [y,n,?,q]