A-12
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
OL-18083-01
Appendix A XECfgParm.dat File Parameters
Understanding the XECfgParm.dat File Format
*.logPrio (continued) • Critical—These messages indicate errors so severe that
a process cannot continue operating.
Note Do not change this value unless you are debugging.
*.LongCallTime Used to generate ongoing Call Data Block (CDB) 1060.
CDB 1060 (on-going call event) indicates a long call in
progress.
Default: 21600000 milliseconds (6 hours)
Minimum value required: 60000 milliseconds (60 seconds)
Note Typically, you should leave the value 21600000
milliseconds (6 hours) as the default. You can change
it, if necessary, based on billing requirements.
If you enter a value less than the required minimum
of 60000 milliseconds, it defaults to 6 hours.
*.M3UA.maxSigServices Defines the maximum number of Message Transfer Part
(MTP) Level 3 User Application (M3UA) signaling services.
It also defines the maximum number of M3UA routing keys.
Valu e: 1536
Note Do not change this value.
*.M3UA.maxOPCs Defines the maximum number of M3UA originating point
codes (OPCs).
Valu e: 64
Note Do not change this value.
*.M3UA.maxRoutesPerOpcDpc Defines the maximum number of M3UA routes per
OPC/destination point code (DPC) pair.
Valu e: 2
Note Do not change this value.
*.M3UA.maxSgp Defines the maximum number of M3UA SS7 signaling
gateway processes.
Valu e: 96
Note Do not change this value.
*.maxLinksPerSessionSet Sets the maximum number of SS7 links contained in a
session set. This is based on the maximum number of SS7
links in a Cisco ITP-L.
Valu e : 4
Default: 4
Note Do not change this value.
Table A-1 Cisco PGW 2200 Softswitch 9.x XECfgParm.dat File Configuration Parameters
Configuration Parameter Definition